The first 24 hours
The first 24 hours after water damage, in order
Answer in brief
Work in this order: make the area safe, stop the water, find out whether the water is clean or contaminated, photograph everything, call your insurer and a restoration company, and start drying. The EPA says wet areas and items should be dried within 24 to 48 hours to prevent mold growth, so the first day matters more than any later one.
Make the area safe before you save anything
Safety first. Water and electricity together can kill. If you smell gas, leave and call the gas utility from outside. For an immediate threat to life, call 911.
The CDC’s guidance for a flooded home is direct about power. If there is standing water and you can reach the main breaker from a dry place, turn the power off, even if that slows the cleanup. If you would have to stand in water to reach the panel, call an electrician. Never switch power on or off, or use an electric tool or appliance, while you are standing in water.
A burst supply line in one room is a smaller event than a flood, but the same rule holds for the wet part of the house. Switch off the circuits that feed wet rooms, and keep cords, power strips and plugged-in appliances out of the water.
Wet ceilings are a second hazard. A sagging, bulging ceiling is holding water and can come down. Stay out from under it.
Stop the water at its source
Most indoor water losses come from the supply side: a failed hose, a split pipe, a leaking water heater or an overflowing fixture. Close the fixture’s own stop valve if you can reach it. If you cannot, close the main shutoff for the house. It is usually where the water line enters the building or at the meter. Find it before you need it.
If the water is coming up through a floor drain, a toilet or a shower, stop using water in the house. Every flush and every load of laundry adds to a backup. A roof leak in a storm cannot be stopped from inside; catch what you can and protect what is under it.
Write down the time you found the water and the time you stopped it. Your insurer will ask, and the drying plan depends on how long materials stayed wet.
Work out whether the water is clean or contaminated
The same amount of water can be a drying job or a demolition job. The difference is what is in it. The restoration industry’s S500 standard sorts water into three categories by contamination, and a category gets worse the longer water sits in a building.
| Where it came from | What it usually means | What to do |
|---|---|---|
| A supply line, a tub or sink overflow with clean water | Clean at the start. It picks up contamination from what it touches and from time. | Safe to start removing and drying yourself if the power is safe. |
| A dishwasher or washing machine discharge, an aquarium, a toilet overflow with urine only | Water that carries some contamination. | Wear gloves. Keep children and pets out. Ask a company how they will clean, not only dry. |
| A sewer backup, a toilet overflow with feces, floodwater from outside | Contaminated. The CDC lists human waste, chemicals and sharp debris among the things floodwater can carry. | Stay out of it. The EPA advises a professional with experience in buildings damaged by contaminated water. |
If you touch contaminated water, the CDC says to wash the skin with soap and clean water as soon as possible, and to wash contaminated clothes in hot water and detergent before you wear them again.
Record the damage before you move things
Take wide photos of every affected room, then close photos of the source, the water line on walls and furniture, and each damaged item. A slow video walk-through with you describing what you see is quick and useful. Photograph the failed part, and keep it.
The Washington insurance commissioner’s claim guidance tells policyholders to be ready with receipts and photos to prove the loss, and to keep copies of everything. Start one folder now. Put in it the photos, the times, the names of the people you speak to and every receipt, including the plumber’s invoice.
Do not throw damaged things away until the adjuster has seen them or has agreed in writing that photos are enough.
Call your insurer and a restoration company
You can make these calls in either order. What matters is that both happen on the first day. Your policy almost certainly requires you to protect the property from further damage, and waiting for an adjuster is not a reason to leave a floor wet.
In Washington, the insurance commissioner states that insurers have five business days to approve a mitigation plan when the policy requires you to protect the property, and that you have the right to select your own contractor. A restoration company that starts emergency drying should give you a written authorization that says what it covers and what it does not.
When you call a company, say where the water came from, when it started, which rooms are wet, what the floors and walls are made of, and whether the power is off. Ask when someone can be there, and ask what the first visit includes.
Start drying inside the 24 to 48 hour window
The EPA’s mold guide says that when wet materials are dried within 24 to 48 hours of a leak, mold will not grow in most cases. You do not have to wait for a crew to begin, if the water is clean and the power is safe.
- Remove standing water with a wet vacuum, a mop or towels. A household vacuum is not built for water.
- Lift rugs, cushions, boxes and books off the wet floor. Put foil or wood blocks under furniture legs.
- Open cabinet doors and closet doors on wet walls so air can reach them.
- In dry weather, open windows. Run fans and a dehumidifier if you have them.
Leave the walls and floors intact. In Washington, L&I requires a good faith asbestos inspection before building materials are disturbed, for homeowners and contractors alike. Drywall compound, sheet vinyl and ceiling texture are common suspects, and you cannot tell by looking.
Follow one day as an example
Worked example · illustrative, not a real job
A washing machine supply hose splits on the second floor at about 6:00 a.m. Water runs for twenty minutes before anyone hears it.
| Time | Action | Why |
|---|---|---|
| 6:20 | Close the washer’s supply valves. Switch off the breakers for the laundry room and the room below. | Stops the source. Removes the shock hazard under a wet ceiling. |
| 6:30 | Photograph the hose, the floor, the ceiling below and the hallway carpet. | The record comes before the cleanup. |
| 6:45 | Wet-vacuum the laundry floor. Move the hallway rug outside. | Liquid water leaves fastest by extraction. |
| 7:15 | Call the insurer’s claim line. Note the claim number and the name. | Starts the claim and the mitigation clock. |
| 7:30 | Call a restoration company. Describe the source, the time and the wet ceiling. | A wet ceiling cavity cannot be dried with a box fan. |
| By evening | Meters show how far the water traveled. Drying equipment is running. A written scope lists what was done. | Day one ends with the structure drying, not waiting. |
Your day will differ. The order should not.
Check your first day against this list
- Power is off to the wet areas, or an electrician has cleared them.
- The source is stopped, and you wrote down when.
- You know whether the water is clean or contaminated.
- Photos and video exist from before anything was moved.
- The insurer has been told and you have a claim number.
- Standing water is gone and air is moving, or a company is on the way.
- No wall, floor or ceiling material has been torn out without an asbestos check.
Superior Water & Fire Restoration publishes its own short version for homeowners: what to do when your house has water damage. The next tutorial explains how drying is measured.
Need help now in Vancouver, WA & Clark County?
Water in your floors, walls or ceiling?
Call Superior Water & Fire Restoration on its own number. Its website says emergency calls are answered 24 hours a day. Say where the water came from, when it started and which rooms are wet.
Call Superior (360) 869-0763Superior: water damage restoration in Vancouver, WA ↗
The phone number is Superior Water & Fire Restoration’s own public number. This site has no form and takes no customer details. For an immediate threat to life, call 911.
Sources & further reading
- CDC: Safety guidelines for reentering your flooded home
- CDC: Safety guidelines for floodwater
- EPA: A brief guide to mold, moisture and your home
- Washington Office of the Insurance Commissioner: Filing a homeowner insurance claim
- Washington L&I: Asbestos
- Superior Water & Fire Restoration: What to do when your house has water damage
Government and standards pages explain the rules and the health guidance. Superior Water & Fire Restoration’s own pages describe its services. No agency or standards body named here endorses Superior Water & Fire Restoration or this site. Worked examples are illustrative, not records of real jobs.
Continue learning
The first 24 hours after water damage, in order
Make it safe, stop the source, record the damage, then start drying. A sequence you can follow with wet socks.
02Drying explainedHow structural drying works: readings, equipment and the drying record
Why a dry-looking wall can still be wet, what the machines do, and how to read the numbers a technician writes down.
03Insurance claimsWater damage insurance claims in Washington: what to document and expect
Sudden or gradual, flood or leak, mitigation or rebuild. The distinctions that decide a claim, and the rights Washington gives you.
Cite this entry
“The first 24 hours after water damage, in order.” Best Water Damage Restoration Companies. Published on behalf of Superior Water & Fire Restoration. Content reviewed . https://bestwaterdamagerestorationcompanies.com/first-24-hours-after-water-damage/